The pellets used are class A1 certified according to standard

ISO 17225-2 (ENplus-A1, DIN Plus or NF 444 of the following

category: “High quality NF biocombustible wood pellets”).

Only the wood pellets supplied are to be used in the pellet stove.

Operation and logic

Once the previously listed points have been checked, press key 1 for three seconds to ignite the stove. During ignition, the stove will check for

a flame for a period of 15 minutes. When the right temperature is reached, the stove will switch from ignition to PREPARATION.

During the preparation phase, the stove stabilises combustion, increasing it progressively, to then start ventilation and switch to WORK

In the work phase, the stove switches to the Set Power defined by the user, heating the room until Set Thermostat is achieved.

Switch-off

Press key 1 for three seconds.

Once this operation has been performed, the appliance automatically enters the switch-off phase, blocking the supply of pellets.

The flue gas exhaust motor and the hot air flow motor will remain on until the stove temperature has dropped below the safety settings.